The purging method of PE pipe is understood
We all understand that PE pipe will leave some dust or other debris in the pipe after a lengthy time of use. We normally use the method of purging to wash these dust. In this process, there are also some problems that we need to pay attention to. Next, we will have a look at the purging process of PE pipe with China HDPE parts factory:
1. Compressed air should be used in the purge experiment for PE pipe, but its temperature should not exceed 40 degrees Celsius as much as possible.
2. In the process of purging, our PE tube products should be isolated from unrelated systems and set up obvious marks.
3. The voltage regulator, water cylinder, valve and additional equipment of PE pipe do not need to participate in the purge. These devices can be installed after the purge is finished and qualified.
4. The purge outlet should be located in a relatively open area and some reinforcement measures should be taken. Remember that the exhaust outlet needs to be grounded and a safe area should be set up when purging the PE pipe.
5. The gas pressure from the purge should not be greater than 0.3MPa.
The above describes some steps when cleaning the PE pipe. It is essential to understand that the working process of PE pipe will continue several times. If you have any problems during the cleaning process of PE pipe, please leave a comment.
4. The purge outlet should be located in a relatively open area and some reinforcement measures should be taken. Remember that the exhaust outlet needs to be grounded and a safe area should be set up when purging the PE pipe.
5. The gas pressure from the purge should not be greater than 0.3MPa.
The above describes some steps when cleaning the PE pipe. It is essential to understand that the working process of PE pipe will continue several times. If you have any problems during the cleaning process of PE pipe, please leave a comment.